- -1GENERAL INFORMATIONAPPROXIMATE ASSEMBLY TIME -2.5 HOURSPLEASE READ COMPLETELY THE ASSEMBLY INSTRUCTIONS BEFORE ASSEMBLY START
- -109REAR BOARD INSTALLATIONPARKING BRAKE INSTALLATION1. Install Parking Brake onto the ROPSbracket with M8 bolts, and nuts. Attach aPa
- -11NOTE:HOW TO RELEASE THE LATCH TO OPEN THE HOODInsert the tools about 300m/m length round stick from the hole of the bottom ofth
- -12TOOL BOX INSTALLATIONNOTE:Use the hardware from Tool box./Holder/M8 bolt (for Holder)/M8 Nut (for Holder)/ Lockwasher (for Holder) /CollarB
- -13THREE POINT LINKAGE INSTALLATION1. Remove the joint pins,1,for the lower linkbars, (already installed on the tractor).2. Install
- -14REAR VIEW MIRROR INSTALLATION1. Install mirror stay to ON R/H side or ON L/Hside with M8 bolts, and nuts.2. Install Mirror to mirror stay with th
- -2The SX21 / SX24 Tractor is shipped partiallydisassembled in a crate.This manual provides the information neededto uncrate and assemble t
- -31. Three Point linkage2. ROPS frame :L&R3. ROPS frame :TOP4. Seat &Seat belt assy.5. Steering wheel6. Steering shaft.7. Front wheels.8. Hardware.③
- -4HARDWARE CARTON BOXTHREE POINT LINKAGE CARTON BOXITEMDESCRIPTIONQTY1Lower links22Top link13Lift rod left14Lift rod right15Check chains
- -5WHEELS INSTALLATIONSIZEMAXInflation pressureFront tire (R4) 18×8.50-8150kPaFront tire (Turf) 18×8.50-8140kPaRear tire (R4) 26×12.00-12170kPaRea
- -6SEAT INSTALLATIONStay ③Bolt ①Plate ②seat supportBolt ④Plate ②Stay ③Seat1. Remove the four bolts,1, and detachthe plate,2,and stay,3,from the
- -7STEERING SHAFT INSTALLATION1. Remove nut, 1,and lock washer,2, fromthe steering wheel shaft2. Install the steering wheel,3,onto the sh
- -8ROPS INSTALLATIONNOTE:use the Hardware from the (CARTON BOX Hardware(for ROPS)Step/Fender bolt kit1. Remove the M12 bolts and nuts from the fende
- -9Install the reflector by using M4 screws and washers(2 points) working from inside of the fender fittinghole.・At this time. The parkin
Kommentare zu diesen Handbüchern